Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
802
This Week
971 results · Page 3/39
Text::LineFold versions through 2019.001 for Perl duplicate the output based on the number of special break characters. Text::LineFold splits the input string by specific line break characters (such as VT, FF and others) into segments, but applies the break function to the entire string, not just the segment. A side effect of this is that the full input can be duplicated for each segment. Besides being incorrect, this can lead to unexpected resource consumption and possible denial of service. Note that Text::LineFold is part of the Unicode-LineBreak distribution, which may have a higher version number than the module.
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: btmtk: validate WMT event SKB length before struct access btmtk_usb_hci_wmt_sync() casts the WMT event response SKB data to struct btmtk_hci_wmt_evt (7 bytes) and struct btmtk_hci_wmt_evt_funcc (9 bytes) without first checking that the SKB contains enough data. A short firmware response causes out-of-bounds reads from SKB tailroom. Use skb_pull_data() to validate and advance past the base WMT event header. For the FUNC_CTRL case, pull the additional status field bytes before accessing them.
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_event: Fix OOB read and infinite loop in hci_le_create_big_complete_evt hci_le_create_big_complete_evt() iterates over BT_BOUND connections for a BIG handle using a while loop, accessing ev->bis_handle[i++] on each iteration. However, there is no check that i stays within ev->num_bis before the array access. When a controller sends a LE_Create_BIG_Complete event with fewer bis_handle entries than there are BT_BOUND connections for that BIG, or with num_bis=0, the loop reads beyond the valid bis_handle[] flex array into adjacent heap memory. Since the out-of-bounds values typically exceed HCI_CONN_HANDLE_MAX (0x0EFF), hci_conn_set_handle() rejects them and the connection remains in BT_BOUND state. The same connection is then found again by hci_conn_hash_lookup_big_state(), creating an infinite loop with hci_dev_lock held. Fix this by terminating the BIG if in case not all BIS could be setup properly.