Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
533
This Week
71 results · Page 1/3
A security flaw has been discovered in mz-automation libiec61850 up to 1.6.1. This vulnerability affects the function Reporting_RCBWriteAccessHandler of the file src/iec61850/server/mms_mapping/reporting.c of the component Report Sending Path Handler. The manipulation results in free of memory not on the heap. It is possible to launch the attack remotely. The exploit has been released to the public and may be used for attacks. Upgrading to version 1.6.2 is able to resolve this issue. The patch is identified as 5b2a69f44256b8548927d8afdd7ac5f5381abe1e. It is suggested to upgrade the affected component. The vendor was contacted early about this disclosure.
In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu/sdma4: replace BUG_ON with WARN_ON in fence emission sdma_v4_0_ring_emit_fence() contains two BUG_ON(addr & 0x3) assertions that verify fence writeback addresses are dword-aligned. These assertions can be reached from unprivileged userspace via crafted DRM_IOCTL_AMDGPU_CS submissions, causing a fatal kernel panic in a scheduler worker thread. Replace both BUG_ON() calls with WARN_ON() to log the condition without crashing the kernel. A misaligned fence address at this point indicates a driver bug, but crashing the kernel is never the correct response when the assertion is reachable from userspace. The CS IOCTL path is the correct place to filter invalid submissions; the ring emission callback is too late to do anything about it. (cherry picked from commit b90250bd933afd1ba94d86d6b13821997b22b18e)
linux
In the Linux kernel, the following vulnerability has been resolved: arm64: contpte: fix set_access_flags() no-op check for SMMU/ATS faults contpte_ptep_set_access_flags() compared the gathered ptep_get() value against the requested entry to detect no-ops. ptep_get() ORs AF/dirty from all sub-PTEs in the CONT block, so a dirty sibling can make the target appear already-dirty. When the gathered value matches entry, the function returns 0 even though the target sub-PTE still has PTE_RDONLY set in hardware. For a CPU with FEAT_HAFDBS this gathered view is fine, since hardware may set AF/dirty on any sub-PTE and CPU TLB behavior is effectively gathered across the CONT range. But page-table walkers that evaluate each descriptor individually (e.g. a CPU without DBM support, or an SMMU without HTTU, or with HA/HD disabled in CD.TCR) can keep faulting on the unchanged target sub-PTE, causing an infinite fault loop. Gathering can therefore cause false no-ops when only a sibling has been updated: - write faults: target still has PTE_RDONLY (needs PTE_RDONLY cleared) - read faults: target still lacks PTE_AF Fix by checking each sub-PTE against the requested AF/dirty/write state (the same bits consumed by __ptep_set_access_flags()), using raw per-PTE values rather than the gathered ptep_get() view, before returning no-op. Keep using the raw target PTE for the write-bit unfold decision. Per Arm ARM (DDI 0487) D8.7.1 ("The Contiguous bit"), any sub-PTE in a CONT range may become the effective cached translation and software must maintain consistent attributes across the range.