Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
0
This Week
8 results · Page 1/1
In the Linux kernel, the following vulnerability has been resolved: HID: hid-goodix-spi: validate report size to prevent stack buffer overflow goodix_hid_set_raw_report() builds a protocol frame in a 128-byte stack buffer (tmp_buf), writing an 11-12 byte header followed by the caller-supplied report data. The HID core caps report size at HID_MAX_BUFFER_SIZE (16384) by default, while the driver does not set hid_ll_driver.max_buffer_size and performs no bounds checking before copying the payload: memcpy(tmp_buf + tx_len, buf, len); A hidraw SET_REPORT ioctl with a report larger than ~116 bytes overflows the stack buffer. Add a size check after constructing the header, rejecting reports that would exceed the buffer capacity. Discovered by Atuin - Automated Vulnerability Discovery Engine.
In the Linux kernel, the following vulnerability has been resolved: Input: goodix - clamp the device-reported contact count goodix_ts_read_input_report() copies the number of touch points reported by the device into an on-stack buffer u8 point_data[2 + GOODIX_MAX_CONTACT_SIZE * GOODIX_MAX_CONTACTS]; which is sized for at most GOODIX_MAX_CONTACTS (10) contacts. The only runtime check bounds the per-interrupt count against ts->max_touch_num, but that value is taken verbatim from a 4-bit field of the device configuration block and is never clamped: ts->max_touch_num = ts->config[MAX_CONTACTS_LOC] & 0x0f; The nibble can be 0..15, so a malfunctioning, malicious or counterfeit controller (or an attacker tampering with the I2C bus) can advertise up to 15 contacts. goodix_ts_read_input_report() then accepts a touch_num of up to 15 and the second goodix_i2c_read() writes ts->contact_size * (touch_num - 1) bytes past the one-contact header into point_data - up to 30 bytes (45 with the 9-byte report format) beyond the 92-byte buffer: a stack out-of-bounds write. Clamp max_touch_num to GOODIX_MAX_CONTACTS, the number of contacts point_data[] is sized for, when reading it from the configuration.