361,222
Total CVEs
26,155
Critical
85,582
High
1,625
CISA KEV
1,975
This Week
25 results · Page 1/1
In Eclipse Jetty, the Digest authentication server-side component uses ISO-8859-1 to encode the password as bytes. This was done because the initial specification for HTTP did not specify explicitly a charset, and it was assumed to be ISO-8859-1 for historical reasons. If the password contains characters that cannot be represented in ISO-8859-1, they are silently replaced by `?`. This happens with passwords that contain Chinese, Cyrillic or Greek characters, for example: `αβ123` converts to `??123`. An attacker can send a request with a digest `Authorization` header crafted with a password made of only `?` characters; the server would match any password of the same length that contains non-ISO-8859-1 characters. Recent HTTP Digest [RFC-7616](https://datatracker.ietf.org/doc/html/rfc7616) supports a `charset` parameters that defaults to UTF-8 that allows for correct encoding/decoding of passwords.
Quinn is a pure-Rust, async-compatible implementation of the IETF QUIC transport protocol. Starting in version 0.1.0 and prior to version 0.11.15, the `Assembler` component that assembles unordered stream fragments into consecutive chunks of the stream incurs some overhead for non-contiguous fragments. Readers that read from a `RecvStream` in order (through an `AsyncRead` impl for example) will be sensitive to peers that send fragments while leaving out early parts of the stream, and in particular, fragments with many gaps (because these cannot be defragmented). In such a scenario, the receiving connection suffers from high buffer overhead, enabling memory exhaustion. Version 0.11.15 fixes the issue.
ngtcp2 is a C implementation of the IETF QUIC protocol. In versions prior to 1.22.1, ngtcp2_qlog_parameters_set_transport_params() serializes peer transport parameters into a fixed 1024-byte stack buffer without bounds checking. When qlog is enabled, a remote peer can send sufficiently large transport parameters during the QUIC handshake to cause writes beyond the buffer boundary, resulting in a stack buffer overflow. This affects deployments that enable the qlog callback and process untrusted peer transport parameters. This issue has been fixed in version 1.22.1. If developers are unable to immediately upgrade, they can disable the qlog on client.
tatsuhiro-t