Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
1,101
This Week
4 results · Page 1/1
In the Linux kernel, the following vulnerability has been resolved: net: wwan: t7xx: validate port_count against message length in t7xx_port_enum_msg_handler t7xx_port_enum_msg_handler() uses the modem-supplied port_count field as a loop bound over port_msg->data[] without checking that the message buffer contains sufficient data. A modem sending port_count=65535 in a 12-byte buffer triggers a slab-out-of-bounds read of up to 262140 bytes. Add a sizeof(*port_msg) check before accessing the port message header fields to guard against undersized messages. Add a struct_size() check after extracting port_count and before the loop. In t7xx_parse_host_rt_data(), guard the rt_feature header read with a remaining-buffer check before accessing data_len, validate feat_data_len against the actual remaining buffer to prevent OOB reads and signed integer overflow on offset. Pass msg_len from both call sites: skb->len at the DPMAIF path after skb_pull(), and the validated feat_data_len at the handshake path.
In the Linux kernel, the following vulnerability has been resolved: net: wwan: t7xx: fix potential skb->frags overflow in RX path When receiving data in the DPMAIF RX path, the t7xx_dpmaif_set_frag_to_skb() function adds page fragments to an skb without checking if the number of fragments has exceeded MAX_SKB_FRAGS. This could lead to a buffer overflow in skb_shinfo(skb)->frags[] array, corrupting adjacent memory and potentially causing kernel crashes or other undefined behavior. This issue was identified through static code analysis by comparing with a similar vulnerability fixed in the mt76 driver commit b102f0c522cf ("mt76: fix array overflow on receiving too many fragments for a packet"). The vulnerability could be triggered if the modem firmware sends packets with excessive fragments. While under normal protocol conditions (MTU 3080 bytes, BAT buffer 3584 bytes), a single packet should not require additional fragments, the kernel should not blindly trust firmware behavior. Malicious, buggy, or compromised firmware could potentially craft packets with more fragments than the kernel expects. Fix this by adding a bounds check before calling skb_add_rx_frag() to ensure nr_frags does not exceed MAX_SKB_FRAGS. The check must be performed before unmapping to avoid a page leak and double DMA unmap during device teardown.
linux