Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
1,322
This Week
89 results · Page 1/4
In the Linux kernel, the following vulnerability has been resolved: spi: microchip-core-qspi: don't attempt to transmit during emulated read-only dual/quad operations The core will deal with reads by creating clock cycles itself, there's no need to generate clock cycles by transmitting garbage data at the driver level. Further, transmitting garbage data just bricks the transfer since QSPI doesn't have a dedicated master-out line like MOSI in regular SPI. I'm not entirely sure if the transfer is bricked because of the garbage data being transmitted on the bus or because the core loses track of whether it is supposed to be sending or receiving data.
linux
In the Linux kernel, the following vulnerability has been resolved: spi: microchip-core-qspi: control built-in cs manually The coreQSPI IP supports only a single chip select, which is automagically operated by the hardware - set low when the transmit buffer first gets written to and set high when the number of bytes written to the TOTALBYTES field of the FRAMES register have been sent on the bus. Additional devices must use GPIOs for their chip selects. It was reported to me that if there are two devices attached to this QSPI controller that the in-built chip select is set low while linux tries to access the device attached to the GPIO. This went undetected as the boards that connected multiple devices to the SPI controller all exclusively used GPIOs for chip selects, not relying on the built-in chip select at all. It turns out that this was because the built-in chip select, when controlled automagically, is set low when active and high when inactive, thereby ruling out its use for active-high devices or devices that need to transmit with the chip select disabled. Modify the driver so that it controls chip select directly, retaining the behaviour for mem_ops of setting the chip select active for the entire duration of the transfer in the exec_op callback. For regular transfers, implement the set_cs callback for the core to use. As part of this, the existing setup callback, mchp_coreqspi_setup_op(), is removed. Modifying the CLKIDLE field is not safe to do during operation when there are multiple devices, so this code is removed entirely. Setting the MASTER and ENABLE fields is something that can be done once at probe, it doesn't need to be re-run for each device. Instead the new setup callback sets the built-in chip select to its inactive state for active-low devices, as the reset value of the chip select in software controlled mode is low.
linux