Loading vulnerability details…
361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
0
This Week
45,566 results · Page 1/1823
In the Linux kernel, the following vulnerability has been resolved: i2c: core: fix NULL-deref on adapter registration failure If adapter registration ever fails the release callback would trigger a NULL-pointer dereference as the completion struct has not been initialised. Note that before the offending commit this would instead have resulted in a minor memory leak of the adapter name.
In the Linux kernel, the following vulnerability has been resolved: net: ethernet: arc: emac: quiesce interrupts before requesting IRQ Normal RX/TX interrupts are enabled later, in arc_emac_open(), so probe should not see interrupt delivery in the usual case. However, hardware may still present stale or latched interrupt status left by firmware or the bootloader. If probe later unwinds after devm_request_irq() has installed the handler, such a stale interrupt can still reach arc_emac_intr() during teardown and race with release of the associated net_device. Avoid that window by putting the device into a known quiescent state before requesting the IRQ: disable all EMAC interrupt sources and clear any pending EMAC interrupt status bits. This keeps the change hardware-focused and minimal, while preventing spurious IRQ delivery from leftover state.
In the Linux kernel, the following vulnerability has been resolved: wifi: brcmfmac: drain bus_reset work on device removal brcmf_fw_crashed() and the debugfs "reset" entry both schedule drvr->bus_reset, whose callback recovers drvr through container_of() and dereferences it. The removal path frees drvr (brcmf_free -> wiphy_free) without draining the work, so a bus_reset callback pending or running during removal can outlive drvr. Cancellation cannot live in brcmf_detach() or brcmf_free(): the work callback reaches teardown through the bus .reset op (PCIe brcmf_pcie_reset -> brcmf_detach; SDIO brcmf_sdio_bus_reset -> brcmf_sdiod_remove -> brcmf_free), so cancelling there would wait for the running work and deadlock. Add a per-bus mutex (bus_reset_lock) and route all arming through brcmf_bus_schedule_reset(), which under the lock skips when the bus is marked removing. Each bus remove entry calls brcmf_bus_cancel_reset_work(), which under the same lock sets removing and cancels the work. Holding the mutex across cancel_work_sync() makes the set-removing + drain step atomic. Every producer reaches the arming path from process context -- the PCIe firmware-halt notification runs in the threaded IRQ handler (brcmf_pcie_isr_thread) and the SDIO hostmail path runs from the data workqueue -- so the mutex is taken only in sleepable contexts. Where applicable the remove entry first stops the firmware-crash producer: on PCIe mask the mailbox and synchronize_irq; on SDIO unregister the bus interrupt and cancel the data worker, which also reports firmware halts through brcmf_fw_crashed(). The mutex is initialized at bus allocation. The SDIO suspend power-off path frees drvr through the same brcmf_sdiod_remove() and takes the same lock; resume re-allows the work only on a successful re-probe. Also guard brcmf_fw_crashed() against a NULL bus_if/drvr: it can fire before brcmf_attach() wires up drvr, and it dereferences drvr (bphy_err/brcmf_dev_coredump) before reaching the arming gate. The bus_reset work is shared across buses, so the drain is applied to every remove path: PCIe (the .reset op introduced by the Fixes commit), SDIO (arms the same work through brcmf_fw_crashed()), and USB (via the debugfs "reset" entry). cancel_work_sync() drains a running or pending bus_reset work item before removal frees drvr, and patch 1/2 makes the scratch-buffer release safe when reset teardown has already released those DMA buffers. This patch fixes the lifetime of the bus_reset work item itself. It does not attempt to address the separate, pre-existing lifetime of the asynchronous firmware completion started by the PCIe reset path. That callback needs its own lifetime/ownership protocol and is being tracked separately. This issue was found by an in-house static analysis tool.