361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
1,906
This Week
11 results · Page 1/1
The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled. As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system. uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service. Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.
zephyrproject
In the Linux kernel, the following vulnerability has been resolved: dm-verity-fec: fix reading parity bytes split across blocks (take 3) fec_decode_bufs() assumes that the parity bytes of the first RS codeword it decodes are never split across parity blocks. This assumption is false. Consider v->fec->block_size == 4096 && v->fec->roots == 17 && fio->nbufs == 1, for example. In that case, each call to fec_decode_bufs() consumes v->fec->roots * (fio->nbufs << DM_VERITY_FEC_BUF_RS_BITS) = 272 parity bytes. Considering that the parity data for each message block starts on a block boundary, the byte alignment in the parity data will iterate through 272*i mod 4096 until the 3 parity blocks have been consumed. On the 16th call (i=15), the alignment will be 4080 bytes into the first block. Only 16 bytes remain in that block, but 17 parity bytes will be needed. The code reads out-of-bounds from the parity block buffer. Fortunately this doesn't normally happen, since it can occur only for certain non-default values of fec_roots *and* when the maximum number of buffers couldn't be allocated due to low memory. For example with block_size=4096 only the following cases are affected: fec_roots=17: nbufs in [1, 3, 5, 15] fec_roots=19: nbufs in [1, 229] fec_roots=21: nbufs in [1, 3, 5, 13, 15, 39, 65, 195] fec_roots=23: nbufs in [1, 89] Regardless, fix it by refactoring how the parity blocks are read.
linux