361,800
Total CVEs
26,223
Critical
85,816
High
1,626
CISA KEV
1,906
This Week
42 results · Page 1/2
In the Linux kernel, the following vulnerability has been resolved: Input: synaptics-rmi4 - bound the F3A keymap to the GPIO count rmi_f3a_initialize() takes the GPIO count from the device query register (f3a->gpio_count = buf & RMI_F3A_GPIO_COUNT, range 0..127). rmi_f3a_map_gpios() then allocates gpio_key_map with min(gpio_count, TRACKSTICK_RANGE_END) == at most 6 entries, but rmi_f3a_attention() iterates the full gpio_count and dereferences gpio_key_map[i], and input->keycodemax is set to the full gpio_count while input->keycode points at the 6-entry allocation. A device that reports gpio_count > 6 therefore causes an out-of-bounds read of gpio_key_map[] on every attention interrupt, and out-of-bounds accesses through the input core's default keymap ioctls: EVIOCGKEYCODE reads past the buffer (leaking adjacent slab memory to user space) and EVIOCSKEYCODE writes a caller-controlled value past it, for any process able to open the evdev node, since input_default_getkeycode() and input_default_setkeycode() only bound the index against keycodemax. Size the keymap for the full gpio_count. The mapping loop is unchanged: it still assigns only the first min(gpio_count, TRACKSTICK_RANGE_END) entries; the remaining slots stay KEY_RESERVED (devm_kcalloc zero-fills) and are skipped when reporting.
In the Linux kernel, the following vulnerability has been resolved: Input: synaptics-rmi4 - bound the F30 keymap to the GPIO/LED count rmi_f30_map_gpios() allocates gpioled_key_map with min(gpioled_count, TRACKSTICK_RANGE_END) == at most 6 entries, but rmi_f30_attention() iterates the full f30->gpioled_count (device query register, range 0..31) and dereferences gpioled_key_map[i], and input->keycodemax is set to the full gpioled_count while input->keycode points at the 6-entry allocation. A device that reports gpioled_count > 6 with GPIO support enabled therefore causes an out-of-bounds read on the attention interrupt and out-of-bounds read/write through the EVIOCGKEYCODE/EVIOCSKEYCODE ioctls, which bound the index only against keycodemax. This is the same defect as the F3A handler, which was copied from F30. Size the keymap for the full gpioled_count; the mapping loop still assigns only the first min(gpioled_count, TRACKSTICK_RANGE_END) entries.
